Although a typical router is powerful enough to fill a small house or apartment with WiFi, it may not boast the range to cover a larger home. As a result, dead zones appear in larger homes or offices. Dead zones or blind spots refer to those areas in a home where you receive poor or zero internet connectivity. Using a WiFi range extender can help you bridge the gaps. A WiFi extender takes the existing signals to every nook and corner of a house or workplace. These devices are easier to use but can be tricky to set up. That’s why we have come up this post in which we are going to discuss some tips and tricks to make your WiFi range extender setup successful. These tips will also help you in getting the superior signal strength even in dead zones. Jot them down carefully.
The placement of your extender plays a key role in signal strength. Therefore, be suspicious and ready to shift your extender if you are getting poor signals. Make sure to put the WiFi range extender to a clean, neat and airy place. However, it should be placed near a power outlet. So carefully look for the place which is dirt free and has a wall socket nearby. Not only the extender placement but your router’s position also affects the setup. So keep the router too as a suitable place.
- Place the device away from obstacles
Your device demands a simple repositioning in case you wish to expand the internet range and coverage to an outdoor location such as a garage or backyard. Bear in mind that metal objects and electronic appliances like microwave ovens, concrete walls, baby monitors, and cordless phones become barriers in the path of signals decreasing their strength. It is recommended to put the extender on an armoire or top of a bookshelf. Once done with the correct extender placement, go through the Netgear extender manual guide which you got on the purchase for setting it up.
- Change network name and password
While configuring the Netgear extender, you will be asked whether to change the default network name and password or not. If you come across the signal overlapping problem, better to customize the name and password of your wireless network. All you have to do is just open a web browser and head over to mywifiext web address.
- Configure your router properly
Before getting started with WiFi range extender setup, check the settings of your existing router once. The router’s settings should be compatible with that of the range extender. To edit the settings of a Netgear WiFi router, launch an internet browser of your choice and enter 192.168.1.250 IP address in the URL bar. Doing so will take you to a dashboard where you can modify the settings in accordance with your preferences.
- Adjust your extender’s antennas
You can easily install and configure a Netgear range extender through mywifiext.net setup page. But during the setup process, there is need to adjust the antennas of your extender. In case your Netgear device comes with removable antennas, you might try replacing them with each other to boost their sensitivity for higher gain. On the other hand, you can even make use of a WiFi reflector to direct the wireless signals in the desired direction.
- Don’t miss any step given on setup wizard
Netgear range extenders guide you with the required steps for setup via a smart wizard. When you log in to mywifiext, you will be presented by a smart setup wizard known as Netgear genie setup. It provides you with a step-by-step guide for extender installation. You have to follow them with great care. If you even miss a single step by mistake, the whole extender setup process will fail. So it is suggested you to take each and every step given on Netgear genie setup wizard seriously. If you still find any difficulty while setting up your range extender, contact our experts directly and let them resolve your technical issues.
So this was our list of surefire tips to make a successful WiFi range extender setup. In case you have your own tips, remember to share them with your fellow readers via the comments section below.